More than an alternative,
it’s an obvious choice!

Proclip®: The custom-made frame that optimizes the set up of your control panel cabinet

Prolight®: The custom-made frame for smaller electrical boxes

More than an alternative, it’s an obvious choice !
  1. Mounting profile PM50 on DIN 35 Mounting profile PM50 on DIN 35
    • Easy addition of screw mount devices
    • Adjustable horizontally and vertically
  2. EAM nuts for groove at the center of profile EAM nuts for groove at the center of profile
    • Easy addition of nuts
    • Allow mounting of DIN35 or PM50 profiles
    • Modular and flexible
  3. PS35 snapped on PP profilePS35 snapped on PP profile
    • Addition of Din rail without screws or hardware
    • Ease the addition of components
  4. DIN35 mounted on PP profilesDIN35 mounted on PP profiles
    • Addition of Din rail
    • Robust solution
  5. ERM nuts for groove at the center of profileERM nuts for groove at the center of profile
    • Inserted in the pre-assembled frame
    • Able to slide in the groove
  6. Mounting profile PM50 mounted vertically on two horizontal profiles PM50Mounting profile PM50 mounted vertically on two horizontal profiles PM50
    • Accommodate device with different bolt pattern
    • Adjustable horizontally and vertically
  7. Vertical profileVertical profile
    • Vertical terminal blocs
    • Cable entry from the side
  8. Mounting profiles PM50 mounted on PP profilesMounting profiles PM50 mounted on PP profiles
    • Easy addition of screw mounted devices
    • Adjustable horizontally and vertically
  9. DIN 35 on 2 SBI snapped on PPA profilesDIN 35 on 2 SBI snapped on PPA profiles
    • 45 degrees’ angle Din rail
    • Accessibility
    • Reduced footprint
  10. PC40 mounted on MSF35 pillarsPC40 mounted on MSF35 pillars
    • Secure cables
  11. Flat profile PPFlat profile PP
    • Flat profile
    • Groove in the center to accommodate nuts and snap in din rail
    • Can be drilled and taped if needed
    • Available from 55mm (2.16in) to 195mm (7.68in) by increments of 20mm (3/4in)
  12. Profile with DIN 35 type PPAProfile with DIN 35 type PPA
    • DIN 35 built in
    • Groove in the center to accommodate nuts
    • Available from 55mm (2.16in) to 155mm (6.10in) by increments of 20mm (3/4in)
  13. U shaped bracket EM80U shaped bracket EM80
    • Bracket 80mm (3.15in) deep for a higher wiring density
    • Plastic cover CP80 to protect the wire from getting damaged by the bracket
    • Available in 45mm (1.77in) depth EM45
  14. Mounting profiles PM50 mounted in between the vertical pillarsMounting profiles PM50 mounted in between the vertical pillars
    • Accommodate recessed components
    • Size optimization without increasing the depth of the cabinet
    • Adjustable horizontally and vertically
  15. FL80/FL45 mounted on the sideFL80/FL45 mounted on the side
    • Closing finish from the side
    • Keep the wiring inside the EM brackets
  16. CEC60 on the side of the frame
    • Closing finish for in between frames
    • Finish between the frame and the side of the cabinet